Shop for New Auto Parts at 1AAuto.com http://1aau.to/c/105/ad/serpentine-belt-tensionerDid you know that squealing belts or pulleys may actually be the resul
HOW TO REPLACE BELT TENSIONER and BELT MITSUBISHI OUTLANDER MITSUBISHI OUTLANDER BELT TENSIONER MITSUBISHI BELTDONATE 😊
Step 1 – Jack the Vehicle. Disconnect the car battery and apply the handbrake. Jack up the front passenger side and place a jack stand for safety. It is recommended for you to draw a diagram or take a photo of the belt route, it might come in handy if you are not a professional car mechanic.
Motorcycles use a toothed belt similar to a timing belt, tension is usually less as it only requires enough tension to keep the teeth firmly engaged in the sprockets. Not sure about an actual tension figure for serpentine belts. It would of course largely depend on the belts' thickness, width, and construction.
Step 5 (slide the belt over a roller): The new belt should be wrapped around the crankshaft pulley and then around the grooved pulleys. Finally, to do the job, slide the belt over a roller that has no grooves or rounded edges. Note: You can watch this video for more detailed information.
Watch this video for step by step instructions! step 1 :Removing the Wheel. 0:30. Loosen the lug nuts with the vehicle on the ground. Raise the vehicle with a floor jack. Secure the vehicle on jack stands. Remove the lug nuts. Pull off the wheel. step 2 :Removing the Serpentine Belt.
. 193 72 181 182 310 55 58 91 229
how to tension a serpentine belt
